Siemens SINUMERIK 840D Operating Manual

Also see for SINUMERIK 840D: Function manual Function manual Function manual Equipment manual Programming manual

Contents

Service Planner (828D only)18.2 Set maintenance tasksMillingOperating Manual, 03/2010, 6FC5398-7CP20-1BA0 55718.2 Set maintenance tasksYou can make the following changes in the list of maintenance tasks in the configurationmode:● Set up a maximum of 32 maintenance tasks with interval, initial warning and number ofwarnings to be acknowledged● Change the interval, time of the initial warning and the number of warnings to be output● Delete a maintenance task● Reset the times of the maintenance tasksAcknowledging a maintenance taskYou can acknowledge the maintenance tasks with the "Servicing performed" softkey.NoteProtection levelYou require protection level 1 (manufacturer) to set up and edit maintenance tasks.Service PlannerDisplay MeaningPos Position of the maintenance task in the PLC interface.Maintenance task Name of the maintenance task.Interval [h] Maximum time until next servicing in hours.1. warning [h] Time in hours at which an initial warning is displayed.Number of warnings Number of warnings that can be acknowledged by the operator beforean alarm message is output for the last time.Remaining time [h] Time until the interval expires in hours.The remaining time cannot be edited.Status Display of the current status of a maintenance task.The maintenance task has been started.The maintenance task is completed.The maintenance task is deactivated, i.e. the time has beenstopped.The status cannot be edited.