Programming technological functions (cycles)8.5 Contour turning - only for G code programsMilling398 Operating Manual, 03/2010, 6FC5398-7CP20-1BA0Parameters Description UnitZD - (only for unmachined part description, cylinder and allowance) For unmachined part description, cylinderAllowance or cylinder dimension (abs or inc) For unmachined part description, allowanceAllowance on the contour (abs or inc)mmAllowance Allowance for pre-finishing - (only for ∇∇∇) YesU1 contour allowance NommU1 Compensation allowance in X and Z direction (inc) – (only for allowance) Positive value: Compensation allowance is kept Negative value: Compensation allowance is removed in addition to finishingallowancemmSet machining arealimitsSet machining area limits Yes– XA: 1. Limit XA ∅– XB: 2nd limit XB ∅ (abs) or 2nd limit referred to XA (inc)– ZA: 1. Limit ZA– ZB: 2nd limit ZB (abs) or 2nd limit referred to ZA NoN Number of groovesDP Distance between grooves (inc) mm8.5.10 Grooving residual material (CYCLE952)FunctionThe "Grooving residual material" function is used when you want to machine the materialthat remained after grooving along the contour.For a G code program, first select the "Grooving residual material" function. Material thatremains as part of the finishing allowance is not residual material. The "Grooving residualmaterial" function allows you to remove unwanted material with a suitable tool.The "Grooving residual material" function is a software option.
