Siemens SIMATIC S5 Equipment Manual

Also see for SIMATIC S5: Manual Manual Manual Manual Manual

R 02/92 Programming InstructionsBEF = AE Modify setpointsSPDB: KY = x, y 0< x <31 Track numberKB : Output of identifier bits, orKB1 : Output of identifier bits (High word) -t Channel 2KB2 : Output of identifier bits (Low word) + Channel 1ST : Output of control bitsBoth setpoints must be specified per track.The track is deleted for interrupt identifier KH = FFFEBEF = SS Software-based synchronizingBEF = SH Hardware–based synchronizingSPDB : KY = x, y x = 32: Zero shift, Channel 1x = 33: Zero shift, Channel 2KB : Output of identifier bits, orKB1 : Output of identifier bits (High word) -t Channel 2KB2 : Output of identifier bits (Low word) -+ Channel 1ST : Output of control bitsIf BEF=SH, the zero shift values are transferred without an SS bit; this isthe precondition for hardware– based synchronizing with preliminary contact andzero mark (see operating instructions).If BEF=SS, the zero shift values are transferred with an SS bit; this ac–complishes software– based synchronization of the counter.1P 241 Equipment Manual@ Siemens AG 1989, Order No.: 6ES5 998-0KD219 – 23Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com