Siemens RX1500 User Manual

Also see for RUGGEDCOM RX1510: Reference guide Installation guide Installation guide User guide Installation manual

Contents

Chapter 5Setup and ConfigurationRUGGEDCOM ROX IIUser Guide792 Managing IPv4 AddressesSection 5.38.3Managing IPv4 AddressesThe following sections describe how to configure and manage IPv4 addresses:• Section 5.38.3.1, “Viewing a List of IPv4 Addresses”• Section 5.38.3.2, “Adding an IPv4 Address”• Section 5.38.3.3, “Deleting an IPv4 Address”Section 5.38.3.1Viewing a List of IPv4 AddressesTo view a list of IPv4 address for a routable interface, navigate to ip » {interface} » ipv4, where {interface} is thename of the routable interface. If addresses have been configured, the Addresses table appears.Figure 912: Addresses TableIf no addresses have been configured, add addresses as needed. For more information, refer to Section 5.38.3.2,“Adding an IPv4 Address”.Section 5.38.3.2Adding an IPv4 AddressTo add an IPv4 address to a routable interface, do the following:1. Change the mode to Edit Private or Edit Exclusive.2. Navigate to ip » {interface} » ipv4, where {interface} is the name of the routable interface.3. Click . The Key Settings form appears.