Siemens RX1500 User Manual

Also see for RUGGEDCOM RX1510: Reference guide Installation guide Installation guide User guide Installation manual

Contents

Chapter 5Setup and ConfigurationRUGGEDCOM ROX IIUser Guide356 Managing IP Ranges for IP PoolsSection 5.15.15Managing IP Ranges for IP PoolsThe following sections describe how to configure and manage IP ranges for IP pools:• Section 5.15.15.1, “Viewing a List of IP Ranges for IP Pools”• Section 5.15.15.2, “Adding an IP Range to an IP Pool”• Section 5.15.15.3, “Deleting an IP Range From an IP Pool”Section 5.15.15.1Viewing a List of IP Ranges for IP PoolsTo view a list of IP ranges configured for an IP pool, navigate to services » dhcpserver » subnet » {name} »options » ippool » {description} » iprange, where {name} is the name of the subnet and {description} is thename of the IP pool. If ranges have been configured, the IP Range Configuration table appears.Figure 388: IP Range Configuration TableIf no IP ranges have been configured, add ranges as needed. For more information, refer to Section 5.15.15.2,“Adding an IP Range to an IP Pool”.Section 5.15.15.2Adding an IP Range to an IP PoolTo add an IP range to an IP pool, do the following:1. Change the mode to Edit Private or Edit Exclusive.2. Navigate to services » dhcpserver » subnet » {name} » options » ippool » {description} » iprange,where {name} is the name of the subnet and {description} is the name of the IP pool.3. Click . The Key Settings form appears.