RUGGEDCOM ROX IIUser GuideChapter 5Setup and ConfigurationDeleting a Prefix Entry 485Section 5.20.3.6Deleting a Prefix EntryTo delete an entry for a dynamic RIP prefix list, do the following:1. Change the mode to Edit Private or Edit Exclusive.2. Depending on the dynamic routing protocol being configured, navigate to routing » dynamic » rip » filter »{name} » entry, where {name} is the name of the prefix list. The Prefix List Entry table appears.1 2 3Figure 551: Prefix List Entry Table1. Add Button 2. Edit Button 3. Delete Button3. Click Delete next to the chosen entry.4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OKto proceed.5. Click Exit Transaction or continue making changes.Section 5.20.4Managing NetworksAs opposed to neighbors, which are specific routers with which to exchange routes, networks are groups ofrouters that are either part of a specific subnet or connected to a specific network interface. They can be used atthe same time as neighbors.NOTEFor point to point links, such as T1/E1 links, specify neighbors instead of a network. For moreinformation, refer to Section 5.20.7.2, “Adding a Neighbor”.NOTERIP v1 does not send subnet mask information in its updates. Any networks defined are restricted tothe classic (i.e. Class A, B and C) networks.NOTEIf neighbors are specified but no networks are specified, the router will receive routing information fromits neighbors but will not advertise any routes to them. For more information about neighbors, refer toSection 5.20.7, “Managing Neighbors”.The following sections describe how to configure and manage networks:
