Sharp SPC562 Instructions & Warranty

USING THE BACKLIGHTPress SNOOZE/LIGHT bar located on the top of the clock to activate the display backlight for 5 seconds. The backlight will stayon for 5 seconds each time it is pressed.USING THE SNOOZETo use the snooze, press the SNOOZE/LIGHT bar when the alarm is sounding. The alarm will be silenced temporarily, but willresume sounding after 5 minutes.CARE OF YOUR CLOCK1. Store the clock without batteries when not in use.2. A soft cloth or paper towel may be used to clean your clock. Do not use corrosive cleanser or chemical solutions on the clock.Keep the clock clean and dry to avoid any problems.3. Avoid putting the clock in a highly humid environment such as poolside or in a bathroom.4. Do not expose the clock to direct sunlight, extreme hot or cold temperatures.Note: Please replace your alarm batteries if beep alarm volume is low or vibration alarm strength is weak.Model SPC562Printed in ChinaModel SPC562IMPORTANT: Extended storage can cause batteries to leak and damage the unit. Leaky batteries should bediscarded immediately. Skin burns or other personal injury can result. Always dispose of batteries according tofederal, state and local regulations.- Clean the battery contacts and also those of the device prior to battery installation.- Remove batteries from equipment that is not to be used for an extended period of time.- Remove used batteries promptly.- Do not mix old and new batteries.- Do not mix alkaline, standard (carbon-zinc), or recharge able (ni-cad, nimh, etc) batteries.

/ 2

Related manuals for Sharp SPC562