Sharp Accu-Set SPC1010ODX Instruction Manual & Warranty

SPC1010ODX Accu-Set Digital Wall ClockInstruction Manual & WarrantyThank you for your purchase of this quality clock. The utmost care has gone into the design and manufacture of yourclock. Please read these instructions and store them in a safe place for future reference.1. LCD display2. Wall mount3.4. TIME SET button5. CAL. SET button6. Lithium batterycompartment7. Battery compartment8. DOWN / C/ F button9. Table stand10. TIME ZONE switch11. RESET button12. DST ON/OFF buttonFEATURESSETTING PROCEDURE FOR THE CLOCKNote: Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries, only batteries of thesame or equivalent type as those recommended are to be used. Do not mix new and old batteries.TEMPERATURE DISPLAYC/ FThe temperature displays indoor temperature. At anytime switch between Celsius or Fahrenheit by pressingbutton.UP / 12/24 button1. Slide the switch to the correct time zone.2. Press the button to turn on the DST function if your area does observe DST.3. Once all above is completed, insert A4. The clock will fast forward to the correct time.1. Press and hold the button, the hour digit will start flashing.2. PPress the button again, the minute digit will start flashing.4. Pbutton again to confirm the setting.1. Press and hold the button, the year digit will start flashing.2. PPress the button again, the month digit will start flashing.4. PRepeat the above steps for date and language, and press the button again to confirm the setting.Press the button to switch between 12 hour or 24 hour display mode.- If you live in an area that does observe DST, press the button to turn on the DST function. The clock will nowadjust automatically each spring and fall to correct for the 1-hour time change.- If you live in area that does not observe DST, such as Arizona, Hawaii, or parts of Indiana, you do not need to do anysetting.The Accu-Set time memory is maintained by a lithium button cell battery, model CR2032. The expected life of thisbattery is about 3 years. Be sure that the two AA/LR6 batteries in the clock are fresh. This battery is located in thesmall battery compartment. Open the lithium battery compartment with a screwdriver and replace the CR2032 lithiumbattery observing the polarity. Then, close the compartment.Before inserting the 2 ì AAî batteries into the battery compartmentTime ZoneDSTMOPTIONALOPTIONALANUAL TIME SET FUNCTIONTIME SETUP DOWNTIME SETUP DOWNTIME SETMANUAL CALENDAR SET FUNCTIONCAL. SETUP DOWNCAL. SETUP DOWNCAL. SET12/24 HOUR DISPLAY12/24DST FUNCTIONDSTREPLACING 3V LITHIUM BATTERY2 / 6 ( ), .x A LR batteries preferably alkaline batteries into the batterycompartment following the polarity as shown on the diagram inside the compartmentress the or button to advance to the correct hour.3.ress the or button to advance to the correct minute.5. Press theress the or button to advance to the correct year.3.ress the or button to advance to the correct month.5.1 2 3 4 5 6 7 8 9 1011 12

/ 2

Related manuals for Sharp Accu-Set SPC1010ODX