Sharp SPC1100 Instructions & Warranty

Also see for SPC1100: Instructions & warranty User manual

Atomic QA Wall ClockInstructions & WarrantyThank you for your purchase of this quality clock. The utmost care has gone into the design and manufacture of yourclock. Please read these instructions and store them in a safe place for future reference.The receiver unit has a clear, easy-to-read display that shows indoor temperature and humidity, outdoor temperature,time, month, date, day. The remote sensor transmits the outdoor temperature. To receive the outdoor temperature,place the sensor anywhere within 30 meters; the 433.92MHz technology means no wire installation is required.The Atomic Clock will always be accurate to within one second as it receives daily WWVB updates. Daylight SavingTime also automatically updates so there is no need to re-set the clock manually!IMPORTANT: If the Atomic Clock does not receive the WWVB signal immediately, wait overnight and it will beset in the morning.The clock has a built in receiver that automatically synchronizes itself with the WWVB radio signal broadcast by theUS Government’s National Institute of Standards & Technology (NIST) in Fort Collins, Colorado.FEATURES:Atomic QA Clock1The WWVB radiosignal daily broadcast ensures that the atomic clock will always display the most accurate date and time.. QA Clock:- Before insert the battery, select the time zone and DST mode. Once battery is inserted, the second hand will runand stop at zero position (12:00), and then the minute and hour hands will start running and stop at zero position.Then, the clock begins to receive the Atomic time signal automatically and it will take 3 - 10 minutes. If successfullyreceive the signal, the hands will find their correct time and work normally.NOTE:1. The unit will automatically search for the time signal at 2:16am, 4:16am, 2:16pm, 4:16pm.2. Closed area such as airport, basement, tower block or factory is not recommended.3. While the atomic signal is flashing, the control panel is inactive.2. LCD DISPLAY:- Displays indoor/outdoor temperature; and current weather condition.3. BATTERY COMPARTMENT AND DOOR:- Use 2 x AA size batteries4. ℃/℉ BUTTON:- In normal mode, press the button to switch temperature unit ℃/℉.SPC1100REMOTE TRANSMITTERRecommended operating range: -50℃ to 70℃, -122℉ to 158℉Resolution: 0.1℃/℉(above 0℃/32℉), 1℃/℉(below 0℃/32℉)Humidity measuring range: 20% RH to 95%RHOperating range: 20% RH to 95%RHResolution: 1%RHRF transmission frequency: 433.92MHzRemote transmitter: 1 unitRF transmission range: maximum 30 metersTemperature sensing cycle: around 50 secondsPOWERMain unit: 1.5V, use 1 x AA 1.5V alkaline battery (for clock movement)3V, use 2 x AA 1.5V alkaline battery (for LCD display)Remote transmitter: 3V, use 2 x AA 1.5V alkaline batteryDIMENSIONMain unit: 273(W) x 360(H) x 5.3(D)mm10.7(W) x 14.2(H) x 2.1(D)inchRemote transmitter: 40(W) x 130(H) x 24(D)mm1.6(W) x 5.1(H) x 0.9(D)inchNOTEChanges or Modifications not expressly approved by the party responsible could void the user's authority to operatethis device.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 ofthe FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turningthe equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures:-- Reorient or relocate the receiving antenna.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-- Consult the dealer or an experienced radio/TV technician for help.RECWWVBM.SE TChannelResetC / FRECWWVBM. SE T1 2 4 5 63 7 9 10 11 12 13 148

/ 2

Related manuals for Sharp SPC1100