68_ web viewerweb viewerCONNECTING WEB VIEWER1. Open your web browser and type the IP address or URLof DVR into the URL address box.M The basic URL of the DVR is as following in case of MACaddress : http://www.samsungipolis.com/User ID You can also use registered URL which setups up in the Setup menu of your DVR.2. Set the Admin ID and password same to those of the DVRAdmin.For general users, enter the DVR user ID and password.J The default password can be exposed to a hacking thread soit is recommended to change the password after installing theproduct.Note that the security and other related issues caused by the unchanged password shall be responsible for the user.M It allows up to 4 simultaneous access including the Admin and general users. It does not allow multiple login of the Admin user. Initial password of the Admin user is set to “4321”. Password of the Admin and general users can be changed in <Permission Management> menu of the DVR. Normal users should have set <Viewer> under <Permission Management> to “Use” before connecting to theWeb Viewer. (Page 37) All settings are applied by the DVR’s settings.3. Click <Install ActiveX Control…>.Downloading Active-X control may take several minutesaccording to the security settings on your PC.4. Click <Install>.
