Managing FabricsZoning59269-00 A 2-21AThe Edit Zoning dialog has a Zone Sets tree on the left and a Port/Device (ormembers) tree on the right. Both trees use display conventions similar to thefabric tree for expanding and collapsing zone sets, zones, and ports. An expandedport shows the port Fibre Channel address; an expanded address shows the portWorld Wide Name. You can select zone sets, zones, and ports in the followingways: Click a zone, zone set, or port icon. Right-click to select a zone set or zone, and open the corresponding popupmenu. Press the Shift key while clicking several consecutive icons. Press the Control key while clicking several non-consecutive icons.Using tool bar buttons, popup menus, or a drag-and-drop method, you can createand manage zone sets and zones in the zoning database. Table 2-3 describes thezoning tool bar operations.Use the Edit Zoning dialog to define zoning changes, and click the Apply buttonto open the Error Check dialog. Click the Error Check button to have QuickToolscheck for zoning conflicts, such as empty zones, aliases, or zone sets, and zoneswith non-domain ID/port number membership. Click the Save Zoning button toimplement the changes. Click the Close button to close the Error Check dialog.On the Edit Zoning dialog, click the Close button to close the Edit Zoning dialog.NOTE:If the Merge Auto Save parameter is enabled on the Zoning Configurationdialog, then every time the active zone set changes, the switch will copy itinto an inactive zone set stored on the switch. You can edit this copy of theactive zone set stored on the switch, and activate the updated copy toconveniently apply the changes to the active zone set. The edited copy thenbecomes the active zone set.Table 2-3. Edit Zoning Dialog Tool Bar Buttons and IconsButton/Icon DescriptionCreate Zone Set button — creates a new zone setCreate Zone button — creates a new zone
