2–Getting StartedSupported ConfigurationsISR654608-00 C 2-3Figure 2-3 shows the configuration used when you are: Migrating from one vendor SAN to another vendor SAN. Installing a new fabric and do not have enough ports available in the oldfabric.This configuration provides data migration rates similar to the direct attachconfiguration (see page 2-1).Figure 2-3. Migration Between Dissimilar Vendor SANsData Migration ConfigurationFigures in this section show the typical configurations used for offline and onlinedata migration using iSR6200 models. Chapter 5 Performing Data Migration andAppendix A Configuring the Data Path Through iSR6200 for Online DataMigration also refer to these figures. The following figure legend applies to all datamigration figures in this section.Table 2-2. Migration Rates for Single Blade ConfigurationSource orDestination ArrayFibreChannelFabricOne Port per ArrayControllerConnected to EachFabricTwo Ports perArray ControllerConnected to EachFabric2Gb Fibre Channel 4Gb 1.25TB/hour 2.5TB/hour4Gb Fibre Channel 8Gb 2.5TB/hour 4TB/hour8Gb Fibre Channel 8Gb 4TB/hour 4TB/hour
