6–Command Line Interfaceset arrayISR654608-00 C 6-63If you have purchased array-based licenses and installed the licenses in theiSR6200, follow these steps to license a specific array for data migration. Forevery array that is licensed, one license is consumed.To apply an array-based license to a specific array in the CLI:1. Open a miguser session using the following command:miguser start -p migration2. To apply a license, enter the following command:set array (see “set array” on page 6-61)3. At the prompt, Do you want to apply array license (yes/no),enter yes.The following example shows the set array command.iSR6200 <1> (miguser) #> set arrayA list of attributes with formatting and current values will follow.Enter a new value or simply press the ENTER key to accept the current value.If you wish to terminate this process before reaching the end of the listpress 'q' or 'Q' and the ENTER key to do so.Index WWPN, PortId Symbolic Name Target Type----- --------------------------------- --------------- -----------0 50:00:1f:e1:50:0a:e1:4c, 01-2b-00 HP HSV200-0 Unknown1 50:00:1f:e1:50:0a:37:18, 01-24-00 HP HSV210-1 Unknown2 50:06:01:69:41:e0:18:94, 01-2d-00 DGC RAID-2 Unknown3 20:70:00:c0:ff:d5:9a:05, 01-0f-ef HP MSA2012fc-3 UnknownPlease select a Target Id from the list above ('q' to quit): 1Symbolic Name (Max = 128 characters) [HP HSV210-1]Target Type (1=SrcTarget, 2=DstTarget, 3=Src+Dest Target) [3 ] 1Bandwidth for Migration (0=Array Bandwidth, 1-400 MBps ) [0 ]Do you want to apply array license (yes/no) [No ]yesAll attribute values for that have been changed will now be saved.All attribute values for Port 2 that have been changed will now be saved.
