A–Configuring the Data Path Through iSR6200 for Online Data MigrationSolaris Multipath ConfigurationISR654608-00 C A-11Solaris Multipath ConfigurationAdding router path for theremoved controller port (forexample, Port B)1. On the HP-UX host after zoning in the second router presentedtarget controller (for example, Port B), issue the ioscan com-mand.2. Issue the scsimgr lun_map command and verify that thenewly-added path is shown as either active or standby.Table A-10. Configuring Native Multipathing on Solaris SPARCOS Solaris 10 SPARCMultipathing software Native MultipathingPre-migration setup 1. To enable multipath on a Solaris host, refer to the followingSolaris document:http://dlc.sun.com/pdf/820-1931/820-1931.pdf2. To verify the multipaths for the LUN, issue the mpathadm listlu command.3. To check the multipath device, issue the luxadm probe com-mand.4. To check the path status, issue one of the following commands:Luxadm -v display <multipath device>mpathadm show lu <device path>Multipath installationverification1. To verify the multipaths for the LUN, issue the mpathadm listlun command.2. To check the multipath device, issue the luxadm probe com-mand.3. To check the path status, issue one of the following commands:luxadm -v display <multipath device>mpathadm show lu <device path>Validations During Router Insertion ProcessRemoving first direct path fromcontroller port (for example,Port A)1. Zone out the first direct path from the Fibre Channel switch.2. To rescan the paths, issue the devfsadm command and verifythat the disabled path is no longer available.3. To check the number of paths now available, issue thempathadm list lu command.4. To check the state of the OFFLINE path, issue the Luxadm -vdisplay <multipath device> command.Table A-9. Configuring Native Multipathing on HP-UX (Continued)
