62[Image compression rate upon alarm detection]Select "On" or "Off" to determine whether or not tochange the image quality upon alarm detection.On: Images will be transmitted with the image qualityselected for "Image quality upon alarm detection".Off: Does not change the image quality upon alarmdetection.Default: Off[Image quality upon alarm detection]Image quality can be changed upon an alarm occur-rence. Select the image quality from the following.0 Super fine/1 Fine/2/3/4/5 Normal/6/7/8/9 LowDefault: 5 NormalConfigure the settings relating to H.264 recording [Alarm]Click the [Alarm] tab on the "Alarm" page.(☞ pages 22 and 23: How to display/operate the setup menu)The settings relating to the recording H.264 data on the SD memory card when an alarm is detected can be config-ured on this page.To operate recording, it is necessary to configure the settings relating to SD memory card and the moving picturedata. (☞ Page 28)[Pre alarm]Determine whether or not to perform the pre-alarmrecording.When "Use" is selected, approx. 1 MB image data isalways saved during the pre alarm recording.Use/Not useDefault: Not use[Post alarm (Recording) duration]Set the duration to save image data on the SD memorycard after an alarm occurrence.10sec/20sec/30sec/40sec/50sec/60sec/120sec/180sec/240sec/300secDefault: 30sec* The actual recording time may sometimes be longerthan the duration selected for this setting.[Recording (Memory) Size per an alarm]The capacity of the SD memory card used to recordvideo data upon an alarm occurrence. (This is just anindication. The actual capacity may be different.)ImportantTo record H.264 data, it is required to select "Use"for "SD memory card" on the [SD memory card] tab.In addition, it is select "H.264" for "Recording for-mat". (☞ Page 28)
