53OTHER FUNCTIONSAlarm Connector and AUX Output ConnectorSecurity doorsensorAlarm input connectorGround terminalAlarm inputAlarm output connectorAUX output connector(To control external devices:for example, lighting ON and OFF)Customizing the Contents of the Alarm MailYou can customize the contents of the alarm mail notifying that an alarm has occurred and the alarm date and time.To customize them, do the following:Create the contents of the alarm mail with a text editor and save the file as "almmail.tmpl".Start up the FTP software and connect to the camera by entering the IP address of the camera.The destination where to transfer the file is "/flash". To login to the camera, enter "admin" for the username and the password registered for the user name "admin" if the password has been changed (thedefault password is "password").Upload the new file (almmail.tmpl) in text format to the camera.STEP3STEP2STEP1You can set the type of the device connected tothe AUX output connector.The settings can be made on the "AUX output"page of "Alarm&Transmission".Click the [Alarm&Transmission] button, and thenclick the [AUX output] tab.The "AUX output" page of "Alarm&Trans-mission" appears and you can check the currentsetting of the "AUX setup".Click the [SET] button after selecting "High" or"Low", according to the specifications of theexternal device to be connected, to enable thesetting.You can set the alarm operation when an exter-nal device such as a sensor is connected to thealarm connector inside the cord cover of thecamera.You can set functions such as sending e-mailsor transferring pictures to the server when analarm signal is input by a sensor, as explained in"Settings of the Actions to be Performed whenMotion is Detected" on page 43.Do not connect an external device if it isbeyond the specified ratings of the camera(refer to page 68).! Important