Panasonic WV-NM100 Operating Instructions Manual

Also see for WVNM100 - NETWORK COLOR CAMERA: Quick reference guide Brochure & specs Operating instructions

Contents

Panasonic WV-NM100 Operating Instructions Manual Manual pdf 42 page image

42DETECTING MOTION IN THE MONITORED AREAWhen motion is detected in the monitored area, "Alarm" appears on the monitor screen. Simultaneously, you cansave the picture of the alarmed area and send an alarm mail by e-mail (motion detector function).You can also automatically transfer the saved image to the server.To activate these functions, complete the setting of the "Alarm" page or the "FTP client" page in advance.• In case a sensor is connected to the alarm connector of the camera, the functions above are available when thesensor detects motion.• To reset an alarm, click "Alarm" on the monitor screen.Motion Detector FunctionBy using the motion detector function, the alarm signal is sent when motion (changes in the brightness level) isdetected in the designated area. With this camera, you can save the picture of the designated area or send an alarmmail when motion is detected.Set the detection area and the other conditions required for the motion detector function on the "VMD area" page.• The motion detector function is available only when "JPEG" is selected for the "Operation mode selection" on the"Operating mode" page of "Advanced setup". The motion detector function does not work when "MPEG-4" isselected.• When the motion detector function is activated, the speed of loading still pictures (JPEG) may become slower.• In case the motion detector function is set to ON, when the brightness level setting is changed an alarm will bedetected.Action when Motion is DetectedBy setting the motion detector function, you can set the camera to activate the following operations when motion(changes in the brightness level) is detected in the designated area.• When motion is detected, "Alarm" appears on the monitor screen asshown in screenshot below."Alarm" will disappear by clicking on it.The camera checks the alarm status and reloads the browser page by theminute or when the reload button is pressed. Therefore, approximately aminute delay at the maximum may occur until "Alarm" appears on the brows-er after an alarm occurred.• You can save the picture of the area where motion is detected on the camera.Number of pictures you can save: 30 pictures max. per 1 alarm (You can set the number of images to be saved upto 20 pictures for pre-alarm and up to 20 pictures for post-alarm, but the total number of images to be saved shouldbe 30 pictures max.)Maximum number of pictures saved: Up to 60 pictures without reference to sizes.The older pictures will automatically be deleted if the number of the pictures exceeds 60 pictures.Setting of the number of pictures to be saved per 1 alarm (for pre-alarm and post-alarm) to secure the space forthe set number of pictures is required in advance. For example, if the number of pictures to be saved per 1 alarmis set to 20 pictures (10 for pre-alarm and 10 for post-alarm), the maximum number of pictures that can be savedwill be 39. (The maximum number of pictures that can be saved is 60 but the space secured in advance for 20 pic-tures and 1 picture which is currently used must be subtracted.)! ImportantNote! ImportantNotes