10MAJOR OPERATING CONTROLS AND THEIR FUNCTIONSFront ViewDome coverPower LEDYou can select ON or OFF for the LED onthe "System" page. (Refer to page 63.)If ON is selected, this LED blinks when thecamera is being accessed.This LED keeps on blinking for around 2minutes even after access is terminated.Note:In MPEG-4 Multicast mode, the LED keepson blinking.Rear ViewHTML document initialization switchPlug the AC adapter into an outlet while this switch is pressed.Keep the switch pressed for five seconds or more, and then release it.Leave the camera without turning the power off (power is being supplied).The camera will start panning and tilting automatically.Initialization of all HTML documents will be completed and all HTML documents will returnto the default settings when the camera stops panning and tilting.It will take around 4 minutes to complete the initialization of all HTML documents.Setting reset switchPlug the AC adapter into an outlet while thisswitch is pressed.Keep the switch pressed for five seconds ormore, and then release it.Leave the camera without turning the power off(power is being supplied).The camera will start panning and tiltingautomatically.Initialization of all the settings will be completedand all the settings will return to the defaultsettings when the camera stops panning andtilting.It will take around 3 minutes to complete theinitialization of all settings.Cord coverTo detach the connector cover, hold down the part and slide it.Alarm connectorPower plug connector(Only use the AC adapter supplied)EthernetconnectorLink LED(Lights up whencommunication withconnected devicesbecomes possible.)Access LED(Lights up whenaccessing to thenetwork.)Inside of the cord coverFirmly insert the power plug of the AC adapter into the power plugconnector of the camera.! Important