Panasonic WV-NF302 Setup Instructions

Also see for WVNF302 - NETWORK CAMERA: Product catalog Integration note Brochure Reference Comparison chart

Panasonic WV-NF302 Setup Instructions Manual pdf 61 page image

61• Are you accessing the wrong IP address?Check the connection as follows:With the Windows command prompt,> ping "IP address of the camera"When the WV-NF302 replies, the camera is functioningnormally.If not, proceed either of the following.• Reboot the camera and change the IP address byusing the Panasonic IP setup software within 20minutes after the reboot.• Reboot the camera with use of the [INITIAL SET]button on the camera. The camera will be initializedand the IP address will return to the default setting"192.168.0.10".After the camera is initialized, access the cameraand set the IP address again. (When the camera isinitialized, all the settings of the camera previouslyconfigured on the setup menus will be initialized.)• Is the LAN cable (category 5) firmly connected to thenetwork connector of the camera?InstallationGuideInstallationGuide• Are the set IP addresses valid?• Is the link LED beside the SD memory card slot of thecamera lit?When it is not lit, connection to a LAN may not beestablished or a network may be not working correctly.Check if the cables have any contact failure or if thewiring is correct or not.• Is the power of the camera on?Check if the power of the camera is turned on.–InstallationGuideTroubleshootingBefore asking for repairs, check the symptoms on the following table.Contact your dealer if a problem cannot be solved even after checking and trying the solution or if the problem is notdescribed below.ReferencepagesCause/solutionSymptomCannot access from the webbrowser.InstallationGuide45