MODEL: Miniature CameraPCF2, PCV2, PCF6, PCV6,PCF6W, PCV6WPRODUCT INSTRUCTIONSSTANDARD INSTALLATION PROCEDURECONTENTS INCLUDE:(1) Dome base(1) Dome(1) Dome liner(1) Camera swivel plate(1) Camera mount with camera, lens, and PC Board(1) Camera adjustment arm(1) Camera adjustment template(2) 4-40 x 1/4" screws(1) 8-32 x 3/8" screwINSTALLATION1. Locate the area on the ceiling or wall where the housing isto be mounted. Cut a hole no larger than 2 1/4" in diam-eter and feed the necessary wires/cable through the hole.2. Remove the dome and liner by turning the dome counter-clockwise and gently pulling down.3. Place the dome base against the ceiling/wall, with thecutout in the center, and mark the keyhole slots. Insert ascrew on each mark and tighten down 3/4 of the lengthof the screw.4. Feed the wires/cable through the hole in the dome base.5. Place the keyhole slots in the base over the screws andslide forwared so that the screws hold the base to the sur-face. Tighten the screws.Dome Tab SlotsKey Hole SlotsWire or Cable EntryATTACHING HOUSING (PCF6/PCV6 PENDANT MOUNT)1. Install 3/4" EMT pipe (not provided) to the desired length.2. Slide the top dome 10" to 12" onto the pipe, leaving enoughroom to work. Run the wiring through the EMT connectorand wiring hole inside the top of the housing.3. Slide complete unit onto the pipe. Tighten the set screwwhenin place.4. Once the housing is secured to the pipe, slide the top domedown onto the top of the housing.3/4" EMT Pipe(not provided)Top DomeHousingDomeLinerManufactured by:forBefore attempting to connect or operate this product, please read these instructions completely.81-IN3047-9922EMT ClampConnectorConnect Class 2 power supply only!!NOTE: Once the housing has been attached to the desiredlocation, connect the power and video wires asrequired.DESCRIPTION: Dome Housing, Color Camera - PCF2, PCV2Pendant Mount Dome Housing, Color Camera - PCF6, PCV6Wall Mount Dome Housing, Color Camera - PCF6W, PCV6WWire or Cable EntryDome Tab SlotsKey HoleSlots