Panasonic Viera TX-P42S30B Operating Instructions Manual

Contents

Panasonic Viera TX-P42S30B Operating Instructions Manual Manual pdf 89 page image

FAQs | On screen messages89Problem ActionsOtherThe remote controldoes not work or isintermittent• Are the batteries installed correctly? (p. 8)• Has the TV been switched On?• The batteries may be running low. Replace them.• Point the remote control directly at the front of the TV (within about 7 mand a 30 degree angle of the front of the TV).• Situate the TV so that sunshine or other sources of bright light do notshine on the TV’s remote control signal receiver.Parts of the TVbecome hot • Temperature rises of parts of the front, top and rear panels will not poseany problems in terms of performance or quality of the TV.Overcurrent errormessage appears• The connected USB device might cause this error. Remove the deviceand turn the TV Off with Mains power On / Off switch, then turn it Onagain.• Check if foreign objects are inside the USB port.An error messageappears• Follow the message’s instructions.• If the problem persists, contact your local Panasonic dealer or theauthorized Service Centre.On screen messagesMessage Meaning / ActionAll tuning data will be erased • [Shipping Condition] will erase all tuning data (p. 49)Are you sure ? • Confirm correct operation.Are you sure you want todelete this timer ?Press OK to delete timer.Press RETURN to return.• Confirm correct operation.Bad signal• The signal is weak. Check the aerial is plugged in properly. It maybe necessary to have an aerial installer check the signal and aerialalignment.• Reset channels. (p. 40)Child Lock is active!Press OK to enter PIN. • The selected channel is locked in Child Lock (p. 47). You must enterthe PIN number before the channel will be displayed.Feature not available.• It is not possible to record from COMPONENT or HDMI. Connectthe recorder to the TV using a fully wired SCART cable for recordingfrom the TV tuner.• Confirm Q-Link or VIERA Link settings (p. 70 - 73)Feature not available.Press OK to view how it works. • The selected feature on VIERA TOOLS is not available. Press theOK button to view the demonstration to explain how to use it.Found new software version ∗∗∗.Press OK to start update (maytake over 40 mins) or pressEXIT to ignore and you canupdate when TV is in standby• There is a new software available.Invalid operation - Please checksettings and connections. • Check the Q-Link or VIERA Link connection and setting (p.70 - 73)Invalid system time. Please exit ! • Cannot get the time information and cannot edit Timer Programmingscreen. Check the connection of the RF cable.Invalid system time, TimerProgramming will not work.Please press TV button onremote control and checktime display on Banner• Cannot get the time information. If there is no time displayed on theInformation banner, check the connection of the RF cable.Max. number of timersalready set ! • The maximum number of timer programming events is 15.