Panasonic Viera TX-P42S30B Operating Instructions Manual

Contents

Panasonic Viera TX-P42S30B Operating Instructions Manual Manual pdf 90 page image

On screen messages90Message Meaning / ActionNew channels found!Press OK to updatechannel list.Press EXIT to ignore.• There may be new channels available.• This message will appear each time a change is made by thebroadcasters. This message can be deactivated by setting [NewChannel Message] to Off in [DVB Tuning Menu].Selecting OK will perform [Update Channel List].No channel found.Please check aerial orlocal signal availability.Press OK to start Auto Setup.• Follow the on screen instructions.• Please also refer to p. 87.• If channels are still not found, consult your local Panasonic dealer.No module inserted • Check the CI module is inserted completely (p. 51).No recording -Already recording • The equipment may already be recording.No recording -Check media • The tape or disc may be “write protected”, full, missing or damaged.No recording - Playing • The equipment may be playing the tape or disc.No recording - Unknown reason • The recording may not be performed. Check the equipment.No service • The broadcaster has stopped the service. Check the channel in the TV Guide. (p. 21)No signal • The TV cannot detect the signal. Check the connection of the RF cable.Overcurrent error on USBdevice occurred.Please remove the USBdevice, and switch off theTV by mains power switch.• The connected USB device might cause overcurrent error. Followthe on screen instructions.• Check if foreign objects are inside the USB port.PIN incorrect! • The PIN number you entered is wrong.Please check settings andconnections on HDMI devices. • Communication error in VIERA Link function (p. 73).Please wait. • A function is in progress.Recording this channelnow • The recorder is recording the programme from its own tuner. You canturn the TV off and leave the equipment recording in the normal way.Reset to Factory ShippingCondition Completed.Please switch off TV.• [Auto Setup] will automatically start when Mains power On / Offswitch is next turned On. (p. 12)Sending Preset Data • Q-Link or VIERA Link channel download is in progress.Software successfully updated.Press EXIT to continue. • The software updating is finished.Software update failed.Please try again later.Press EXIT to continue.• Perform [System Update Search Now] in System Update (p. 52).If this is still unsuccessful, there may not be any new software available.The device is not directlyconnected to the TV.The device may not work correctly. • Please do not connect the device via a USB HUB.This timer will not followthe TV Guide information.Press OK to continue, RETURNto restore original timer.• If you edit the start time or end time of Guide link programming by morethan 10 minutes, it will no longer be performed as Guide link programming.The programming will be performed according to the time setting.Timer already expired ! • The starting time in Timer Programming has already passed.Set the timer correctly (p. 46).Timer incorrect ! • Set the start and end times in Timer Programming correctly (p. 46).Timer overlap.Press OK to keep,RETURN to edit.• Timer programming events are overlapped. Press the OK buttonto keep the overlapped setting. [Ext Rec.] is given priority over[Reminder]. When two or more [Ext Rec.] overlap, the first timerprogramming event starts and finishes as programmed. The nexttimer programming event can then start.Tuner LockedPress EXIT to unlock andstop recording• If you want to unlock the tuner, cancel Direct TV Recording(p. 72, 74) or the recording of Timer Programming (p. 46).Unable to download,please check equipment • The tape or disc is active. Stop the equipment and try again.