Panasonic VL-SW102BX Operating Instructions Manual

Also see for VL-SW102BX: Installation guide

Contents

Panasonic VL-SW102BX Operating Instructions Manual Manual pdf 26 page image

Camera (optional)26Features of the cameraCamera monitor:You can monitor the image and sound of the other room where the camera is located by using the main monitor station or thesub monitor station. The quality of the images taken by the camera is a little lower than the quality of the images taken by thedoor station.When the camera sensor detects temperature variations:The ringer tone sounds and the image taken by the camera is displayed on the main monitor station and the sub monitorstation.The image taken at the time of detection and 3 more images (4 images in total) are automatically recorded at about a 3second interval after detection. Even if you do not answer a call, the image is recorded and you can review the recordedimage anytime (page 30).Camera image displayed on the main monitor station:4 refreshed images taken by the camera are displayed on the main monitor station every 3 seconds. You can select either “4PICTURES” (default setting) or “1 PICTURE” in the function setting for “NUMBER OF CAMERA PICTURES” (page 39).The image quality of “1 PICTURE” is lower than “4 PICTURES” because the image of “1 PICTURE” is enlarged to the fulldisplay size.Note:L�You can zoom in the image from the camera. This feature must be set beforehand: (“ZOOM” on page 40).L�When the sensor detects, the camera sounds a ringer tone “CAMERA RINGER”. You can change the ringer pattern:(“CAMERA RINGER” on page 40) or the ringer volume: (“CAMERA RINGER VOLUME” on page 40).L�After detecting motion, the sensor does not detect for about 60 seconds. You can change the time interval of detection:(“SENSOR TYPE” on page 40).L�The automatic recording mode can be deactivated: (“SENSOR TYPE” on page 40).