English - 8 -Inserting the Batteries into the RemoteRemove the back cover to reveal the battery compart-ment. Insert two size AA batteries. Make sure the (+)and (-) signs match (observe correct polarity). Do notmix old and new batteries. Replace only with same orequivalent type. Place the cover back on.A message will be displayed on the screen when thebatteries are low and must be replaced. Note that whenthe batteries are low, the performance of the remotecontrol may be impaired.Batteries should not be exposed to excessive heatsuch as sunshine, fire or the like.Power ConnectionIMPORTANT: The TV set is designed to operate on a220-240V AC, 50 Hz supply. After unpacking, allow theTV set to reach the ambient room temperature beforeyou connect the set to the mains. Plug the power cableto the mains socket outlet.Antenna ConnectionConnect the aerial or cable TV plug to the AERIALINPUT (ANT-TV) socket located on the rear side ofthe TV.Rear side of the TVANT-TVIf you want to connect a device to the TV, makesure that both the TV and the device are turned offbefore making any connection. After the connectionis done, you can turn on the units and use them.License NotificationThe terms HDMI and HDMI High-Definition MultimediaInterface, and the HDMI Logo are trademarks orregistered trademarks of HDMI Licensing Administrator,Inc. in the United States and other countries.Manufactured under license from Dolby Laboratories.Dolby, Dolby Audio and the double-D symbol aretrademarks of Dolby Laboratories.YouTube and the YouTube logo are trademarks ofGoogle Inc.This product contains technology subject to certainintellectual property rights of Microsoft. Use ordistribution of this technology outside of this productis prohibited without the appropriate license(s) fromMicrosoft.Content owners use Microsoft PlayReady™ contentaccess technology to protect their intellectual property,including copyrighted content. This device usesPlayReady technology to access PlayReady-protectedcontent and/or WMDRM-protected content. If thedevice fails to properly enforce restrictions on contentusage, content owners may require Microsoft to revokethe device’s ability to consume PlayReady-protectedcontent. Revocation should not affect unprotectedcontent or content protected by other content accesstechnologies. Content owners may require you toupgrade PlayReady to access their content. If youdecline an upgrade, you will not be able to accesscontent that requires the upgrade.The “CI Plus” Logo is a trademark of CI Plus LLP.This product is protected by certain intellectual propertyrights of Microsoft Corporation. Use or distribution ofsuch technology outside of this product is prohibitedwithout a license from Microsoft or an authorizedMicrosoft subsidiary.