23(From the On screen Display menu)It is possible on individual programme position.1 Press to select the Manual tuning.Press to access the Manual tuning screen.2 Press to select the desired Programme Number.Press to search the higher or lower channel.3 When the desired station is found, press to store.The programme position will flash.4 Press to exit from the Tuning Menu.This returns the set to the normal viewing condition.Tuning menuManual TuningManual tuning of the programme position is available either from the On Screen Display menu or from the side panelcontrols.Turn the TV on and select the broadcast channel. Follow the step on the previos page to disply the Tuning menu screen.Decoder (AV2)Volume correc.Programme editAuto setupManual tuningFine tuningColour systemTuning menuAccessAutoOffHelpful Hint(1) If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the“Colour System Selection” operation on page 26.(2) When using a VCR without video and audio input/output terminals, it is convenient to connect the aerial cable asindicated in the instruction manual of VCR and to set the designated channel to programme No. “0”. In that case,perform manual tune after setting the colour system in advance. Further, in multi-system VCR, it is more convenientto set the designated channel to several programme Numbers.02 99:21 41Manual tuningTV/AV’STR’ Button StareE x i tSerchdown / upProgrammedown / upReturnTV/AVSearch Start.(Via side panel)1 Press (Side panel) until Tuning mode is reached.2 Press or to access Tuning mode.3 Press to move between Change programme, search and TV system.4 Press or to change programme position or start search.When the desired station is found, press to store.The programme position will flash.Repeat above procedure to tune additional programme positions.Press at any time to exit the Tuning menu.(LCD TV Set)3124Manual tuning (Side panel)-, + : SearchTV/AV : Move cursorSTR : StoreF : To exit02 99:21 41STR