- 51 -■ Analogue TVSet Analogue TV channel manually after Auto Tuning.1. Select the channel position with numeric buttons2. Select the channel with Channel Up / Down button3. Search with /4. Select Store with / and press OK to set● If a VCR is connected only with the RF cable, select channel position 0.Update Channel ListBy updating the Digital TV channel list, you can add new channels, deleteremoved channels or change channel names and positions automatically.● The channel list is updated while keeping your settings in Favourites Edit,Channel List, Child Lock, etc.● Depending on the signal condition, the update may not work properly.New Channel MessageSelects whether to give a notification message when a new Digital TVchannel is found.● When a notification message appears, you can perform Update ChannelList pressing OK.● Sometimes, mainly during summer months at night, the TV may pick updistant TV stations outside your broadcast due to favourable short termionosphere conditions. In such circumstances when you press OK, the TVdoes not add any new channels. This is normal.Signal ConditionSelects a channel and checks the signal condition.A good Signal Strength is not an indication of suitable signal for Digital TVreception.● Use the Signal Quality indicator as follows.– Green bar: Good– Yellow bar: Poor– Red bar: Bad (Check the aerial)● Vertical lines show the maximum signal value of the selected channel.
