8Notes on Using Wireless ConnectionWired LAN■ Use straight or crossover LAN cable that is compatible with category 5 or above.Whether straight cable, crossover cable or both can be used varies depending on the system configuration. For details,¼consult your system administrator.When setting up the Display at a place, where electric statistic occurs often, take a sufficient anti-static measure beforestart using.When the Display is used at a location, where static electricity occurs often, such as on a carpet, communications of¼the DIGITAL LINK and the wired LAN are disconnected more often. In that case, remove static electricity and the noisesource that may cause problems with an antistatic mat, and re-connect the DIGITAL LINK and the wired LAN.In rare cases, the LAN connection is disabled due to static electricity or noise. In that case, turn off the power of the¼Display and the connected devices once and then re-turn on the power. Connect the DIGITAL LINK and the LAN.The Display may not work properly due to strong radiowave from the broadcast station or the radio.If there is any facility or equipment, which outputs strong radiowave, near the installation location, set up the Display¼at a location sufficiently far from the source of the radiowave. Or, wrap the LAN cable connected to the DIGITAL LINKterminal by using a piece of metal foil or a metal pipe, of which is grounded at both ends.■ Available wireless LAN channelsThe channels (frequency range) that can be used differ according to the country or region. Refer to the table below.Country or region Standard Channels used Frequency band (Center frequency)GlobalIEEE802.11a/n Passive scanning 5.180 GHz - 5.825 GHzIEEE802.11b/g/n Passive scanning 2.412 GHz - 2.472 GHzThe frequency and channel differ depending on the country.¼The passive scanning is performed by changing radio to the channel being scanned in each country.¼Please use the wireless LAN feature in compliance with the laws of each country.¼For Mexico:■ Operation of this equipment is subject to the following two conditions:(1) this equipment might not have a harmful interference and(2) this equipment must accept any interference, including one that might cause it to malfunctionFor Jamaica:■ This product contains Type Approved Modules by Jamaica.•