Panasonic TH-80OLFB70U Operating Instructions Manual

Also see for TH-50LFB70E: Operating instructions Operating instructions

Panasonic TH-80OLFB70U Operating Instructions Manual Manual pdf 21 page image

21DIGITAL LINK statusDisplay the DIGITAL LINK connection environment.Select “DIGITAL LINK status” in [Network Settings]menu, and press .DIGITAL LINK statusLINK statusHDMI statusSignal QualityMinimumMaximumNo LinkNo HDMI-XX dB-YY dBLINK status : Either “No link”, “DIGITAL LINK”, or “Ethernet” will be displayed.No link : No LAN connection, etc.DIGITAL LINK : Connected to the DIGITAL LINK device by LANEthernet : The PC is connected to the DIGITAL LINK terminal of this product and isLAN connectedHDMI status : Either “No HDMI”, “HDMI ON”, or “HDCP ON” will be displayed.No HDMI : DIGITAL LINK not connectedHDMI ON : DIGITAL LINK connectedHDCP ON : A signal with an HDCP is flowing with a DIGITAL LINK connection.Signal quality : It is the quantified minimum and maximum numbers of errors that have occurred. The displaycolors are red, yellow, or green, depending on the number.The number is represented by yellow or red if the LAN cable is disconnected or the cable isnot shielded. This signal quality shows figures between the twisted pair cable transmitter that isconnected and the display.Signal Quality Display Colors Reception Status-12dB or below Green The reception is normal-11 to -8dB Yellow Part of the receiveddata is corrupted-7dB or above Red There are receptiondifficultiesDigital Interface BoxA switch will be made to the Set up Digital Interface Box menu when “Digital Interface Box” in [Network Settings]menu is selected and is pressed.This function can only be selected when the Digital Interface Box (ET-YFB100G) made by our company is connectedto a LAN terminal and its power is on.Network SettingsLive mode Cut InSet this [ON] to allow interrupt of the Live mode by other users while the Live mode is active (sending image) by the“Wireless Manager”. For details, refer to “Wireless Manager” operating manual.Select [Live mode Cut In] in [Network Settings] menu and press1 button.Select [On] or [Off].2