Panasonic TH-80OLFB70U Operating Instructions Manual

Also see for TH-50LFB70E: Operating instructions Operating instructions

Panasonic TH-80OLFB70U Operating Instructions Manual Manual pdf 17 page image

17Network SettingsPress ▼ to go to the next item.4 In addition, further perform the following setting depending on [Authentication] and [Encryption] settings.Default KeyKey 2 *******Key 1 *******1Key 3 **************Key 4●method:Default Key : Set 1 – 4 numerals for the default key.Key1 – 4 : Set a WEP key to the key number selected with [Default Key].Either the 64-bit or 128-bit WEP key can be set. For the 64-bit key, input fivealphanumerics (or a 10-digit string for the hexadecimal format) for the 128-bit key,input 13 alphanumerics (or a 26-digit string for the hexadecimal format).When using [WPA-PSK] or [WPA2-PSK] :● Set a key.Input either 8 to 63 alphanumerics or a 64 digit string in the hexadecimal format.When the authentication method is [WPA-EAP/WPA2-EAP], [WPA-EAP], [WPA2-EAP]:●Set [EAP], [User name], and [Password].EAP: Select the EAP setup in the RADIUS server. Types of EAP that can be selected are asfollows.PEAP (MS-CHAPv2), PEAP (GTC), EAP-TTLS (MD5),EAP-TTLS (MS-CHAPv2), EAP-FAST(MS-CHAPv2), EAP-FAST(GTC)User name: Input a user name used for authentication (excluding spaces)(maximum 64 characters).Password: Input a password used for authentication (maximum 64 characters).Entering characters page 18If you are unable to connect to the wireless LAN through the access point, contact the manufacturer of• the access point.When using EAP, the display needs to be set according to the setting of the RADIUS server. Check with• the network administrator for the setting of the RADIUS server.When using an EAP together with an access point with invalid SSID broadcast, select WAP-EAP or• WAP2-EAP for the authentication method even if the authentication method of the access point is WPA-EAP/WPA2-EAP.Select [Save] and press5 button.Save the current network settings.Default settings of [USER1] - [USER3]■ The following settings as [USER1] - [USER3] in the [Wireless LAN] are set before the Display leaves thefactory.SSID Panasonic Display Authentication OpenDHCP Off Encryption NoneIP address 192.168.11.100Subnet mask 255.255.255.0Gateway 192.168.11.1