Panasonic TH-55LFV70U Operating Instructions Manual

Also see for TH-55LFV70U: Operating instructions Operation instruction Operating instructions

Contents

Panasonic TH-55LFV70U Operating Instructions Manual Manual pdf 46 page image

46SETUPDiaplay ID auto setupAutomatically sets an ID number. An ID number is automatically assigned to a display connected via DIGITAL LINK.StatusDisplays the implementation status of Display ID auto setup.Operating: the auto setup is in progress.No connection: DIGITAL LINK is not connected. (No connection can bedetected)Error: a wrong DIGITAL LINK connection has been made.Wait: the auto setup has yet to be implemented.Finished: the auto setup has been completed.Display ID Auto SetupStatus WaitDIGITAL LINK daisy chain 1 / 2Display ID 1Network control / IP address OnOff192.168.0.8DIGITAL LINKDIGITAL LINKOff Built-inSerial ID / TerminalSerial out terminalController out terminalController ID / TerminalIR OUTDisplay IDStartChanging network controlChanging serial/IR terminalAutoYesYesDIGITAL LINK Daisy Chain ( A / B )A: Displays the i-th unit of the displays connected via DIGITAL LINK.B: Displays the total number of displays connected via DIGITAL LINK.Display ID:Displays an ID number obtained by the auto setup.Network control / IP address: ( A / B )A: Displays the disable / enable state of the Network control function.B: Displays the IP address of this display.Serial ID / Terminal: ( A / B )A: Displays the disable / enable state of the ID control function for serial communication.B: Displays which terminal to use for input for serial communication.Serial out terminal:Displays which terminal to use for output for serial communication.Controller ID / Terminal: ( A / B )A: Displays the disable / enable state of the ID control function for remote control operation.B: Displays which sensor / terminal to use for remote control signal input.Controller out terminal:Displays which terminal to use for remote control signal output.Start:Starts the auto setup of a display ID.Display ID:Auto: The display ID will be set automatically, based on the order of connected by DIGITAL LINK.1 ~100 : Sets the origination of the display ID.Changing network control:Sets whether to change the network settings or to retain the current settings as the auto setup of display ID isimplemented.Options: No: retains the settings.Yes: Set to “On” to “Network control”.Changing serial/IR terminal:Sets whether to change the control terminal settings for RS232C/IR or to retain the current settings as the autosetup of display ID is implemented.Options: No: retains the settings.Yes: For the display connected by DIGITAL LINK, set to “DIGITAL LINK” for the settings of each input-outputterminals of RS232C and controller.Note: For the display connected only input side or output side, the setting of connected side is changed. For thedisplay connected by DIGITAL LINK, set to “DIGITAL LINK” for the settings of each input-output terminal ofRS232C and controller.