Panasonic TH-55LFV70U Operating Instructions Manual

Also see for TH-55LFV70U: Operating instructions Operation instruction Operating instructions

Contents

Panasonic TH-55LFV70U Operating Instructions Manual Manual pdf 39 page image

39Adjusting POSITIONH-position Adjust the horizontal position. V-position Adjust the vertical position.H-Size Adjust the horizontal size. V-Size Adjust the vertical size.ClockPhase(With PC input signal and when "RGB " is selected for "Component switching“)Eliminate the flickering and distortion.Dot Clock (With PC input signal and when "RGB " is selected for "Component switching“)Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, adjust sothat any such noise is minimized.Over Scan Turn image over scan On/Off.Configurable signals are as follows:525i, 525p, 625i, 625p, 750/60p, 750/50p (HDMI, DisplayPort, DVI-D IN 1, DVI-D IN 2, DIGITAL LINK, COMPONENTVIDEO, VIDEO)On OffNotes:• “Off” is effective during only “16:9” aspect mode.• When “Off” is set, “H-Size” and “V-Size” cannot be adjusted.1:1 PixelModeAdjusts the display size when 1125i or 1125p signal is input.Notes:• “On” is effective during only “16:9” aspect mode.• Select On when you would like to replay 1920 × 1080 input signal.• Applicable input signal:1125 (1080) / 50i · 60i · 24PsF · 24p · 25p · 30p · 50p · 60p• Select Off when flickering is shown around the image.• H-Size and V-Size cannot be adjusted when On is selected.Off OnNotes:• Depending on the input signal, the adjustable range for screen position differs.If positions other than the adjustable range are selected, the position does not change.Helpful Hint: ( / DEFAULT )While the POSITION display is active, if either the DEFAULT button on the remote control is pressed at any time or the ENTERbutton is pressed during “DEFAULT”, then all adjustment values (except “Clock Phase” and “Dot Clock”) are returned to the factorysettings.