Panasonic TH-42LF30ER Operating Instructions Manual

Also see for TH-42LF30ER: Service manual Operating instructions

Contents

Panasonic TH-42LF30ER Operating Instructions Manual Manual pdf 44 page image

44Options AdjustmentsItem AdjustmentsPower ON ScreenDelayOff 1 2 3.... 30You can set the power-on delay time of the displays to reduce the power load, when you press toturn on the multiple displays that are set together, for example, on MULTI DISPLAY system.Set each display’s setting individually.Off: The display will be turned on at the same time as is pressed.1 to 30 (sec.) : Set the power-on delay time (second).After pressing , the display will be powered on with time delay depending on this setting.Notes:• During this function is working, the power indicator is blinking green.• This function also works when the power recovers from failure or after plugging off and in again thepower cord.Clock DisplayOff: Not display the clock.On: Display the clock.The clock is displayed at the lower left of the screen when button is pressed.Note: When “PRESENT TIME Setup” is not set, the clock is not displayed evenif “Clock Display” is “On”. (see page 27)10:00Power On Message(No activity poweroff)Whether to show/hide No activity power off Precautions at the time of power ON is set.On: The warning precautions are shown at the time of power ON.Off: The warning precautions are not shown at the time of power ON.Note: This setting is enabled only if “No activity power off” is “Enable” (see page 31).Function button assign 1Function button assign 2Set the functions that operates when is pressed.Signal: The “Signal” menu is displayed.Screensaver: The “Screensaver” menu is displayed.ECO menu: The “ECO Mode settings” menu is displayed.Set up TIMER: The “Set up TIMER” menu is displayed.Note:Factory settings are as follows.FUNCTION1 button: SignalFUNCTION2 button: ScreensaverUse the FUNCTION buttonThe menu screen is displayed. (Example: Signal)3D Y/C FilterColour systemSignalOnAutoCinema reality Off[ AV ]Noise reduction OffPress the FUNCTION button to exit from the menu.NormalisationWhen both main unit buttons and remote control are disabled due to the “Button lock”, “Remocon User level” or“Remote ID” adjustments, set all the values “Off” so that all the buttons are enabled again.Press the button on main unit together with button on the remote control and hold for more than 5 seconds. The“Shipping” menu is displayed and the lock is released when it disappears.