Panasonic TH-42LF30ER Operating Instructions Manual

Also see for TH-42LF30ER: Service manual Operating instructions

Contents

Panasonic TH-42LF30ER Operating Instructions Manual Manual pdf 43 page image

43Options AdjustmentsItem AdjustmentsInput lockLocks the input switch operation.Off SLOT INPUT* VIDEO Component/RGB PC DVI HDMI1 HDMI2 Off* “SLOT INPUT” is displayed when an optional Terminal Board is installed.Notes:• Only the adjusted signal is displayed (see page 16).• Input switch can be used when this is set to “Off”.Button lockOff On MENU&ENTEROff: All the buttons on main unit can be used.MENU&ENTER: Locks MENUand ENTER/buttons on main unit.On: Locks all the button on main unit.Sets Button lock with the unit buttons in the following procedure.Off: Press four timesĺPress INPUTfour timesĺPress four timesĺPress ENTER/MENU&ENTER: PressENTER/four timesĺPress four timesĺPressINPUTfour timesĺPress ENTER/On: Press four timesĺPress ENTER/four timesĺPress four timesĺPress ENTER/Remocon User levelOff User1 User2 User3Off: You can use all of the buttons on the remote control.User1: You can only use , , , , buttons on the remote control.User2: You can only use button on the remote control.User3: Locks all the buttons on remote control.Off-timer functionEnable: Enables the “Off-timer function”.Disable: Disables the “Off-timer function”.Note: When “Disable” is set, the Off-timer is cancelled.Initial Power ModeNormal On StandbySets the power mode of the unit for when the power recovers from failure or after plugging off and in again.Normal: Power returns in as the same state as before the power interruption.Standby: Power returns in standby mode. (Power Indicator : red/orange)On: Power returns in power On. (Power Indicator : green)Note: When using multiple displays, “Standby” is preferred to be set in order to reduce a power load.ID selectSets panel ID number when panel is used in “Remote ID” or “Serial ID”.Set value range: 0 - 100(Standard value: 0)Remote IDThe setting of this menu is valid only when using ID remote control.Off: Disables ID remote control functions. You can use normal remote control operations.On: Enable ID remote control functions.Note: To use the ID remote control function, it is necessary to set each ID number of remote control anddisplay unit. About the setting method, please refer to “ID Remote Control Function” (see page36) and “ID select” (above-mentioned).Serial IDSets the panel ID Control.Off: Disables external control by the ID.On: Enables the external control by the ID.Serial Daisy ChainSets the top and end of a daisy chain when the SERIAL terminal of Display is daisy chained.---: When the Display is under SERIAL control on a standalone basis, or if not at the top or end of daisychain.Top: To connect to the top of daisy chain.End: To connect to the end of daisy chain.Studio W/BOff: Nullify all the settings adjusted.On: Sets the colour temperature for TV studio.Note: Valid only when the “Warm” is set as “White balance” in Picture menu.Slot powerOff Auto OnOff: Power is not transmitted to the slot power.Auto: Power is transmitted to the slot power only when main power is on.On: Power is transmitted to the slot power when main power is on or in the standby state.Note: In some cases, power is transmitted to the slot power when main power is on or in the standbystate regardless of the slot power setting.