Panasonic TH-42LF30ER Operating Instructions Manual

Also see for TH-42LF30ER: Service manual Operating instructions

Contents

Panasonic TH-42LF30ER Operating Instructions Manual Manual pdf 11 page image

Notes:• Computer signals which can be input are those with a horizontal scanning frequency of 30 to 110 kHz and vertical scanningfrequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)• The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to “4:3”, and 1,920 × 1,080dots when the aspect mode is set to “16:9”. If the display resolution exceeds these maximums, it may not be possibleto show ¿ne detail with suf¿cient clarity.• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you willneed to make setting changes to the computer at the time of connection.• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.• The computer shown in the illustration is for example purposes only.• Additional equipment and cables shown are not supplied with this set.• Panasonic recommends using a PC cable that includes a Ferrite core.• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the speci¿edfrequency range.PC Input Terminals connectionConversion adapter(if necessary) Mini D-sub 15pRGBPC cable withFerrite coreStereo mini plug (M3)AudioConnect a cable which matchesthe audio output terminal on the computer.(Male)(Female)COMPUTERSignal Names for Mini D-sub 15P ConnectorPin Layout for PC InputTerminalPin No. Signal Name Pin No. Signal Name Pin No. Signal Name1 R 6 GND (Ground) 11 NC (not connected)2 G 7 GND (Ground) 12 SDA3 B 8 GND (Ground) 13 HD/SYNC4 NC (not connected) 9 +5 V DC 14 VD5 GND (Ground) 10 GND (Ground) 15 SCL167839451015 14 13 12 11211ConnectionsShared with DVI-D IN.