Panasonic TH-103PB1U Operating Instructions Manual

Also see for TH-103PB1E: Operating instructions Service manual

Contents

Panasonic TH-103PB1U Operating Instructions Manual Manual pdf 34 page image

34Set Touch Pen mode.Select “Touch-Pen Settings” in “Setup” menu and press button.When a Terminal Board with dual input terminals is installed, “SLOT INPUT” isdisplayed as “SLOT INPUT A” and “SLOT INPUT B”.Touch-Pen SettingsTouch-Pen Mode Touch OnlyTouch-Pen SettingsOffSLOT INPUTOffOffPCHDMIDVIOffOffNETWORKTouch-Pen ModeSelect an appropriate setting for the function of the electronic pen used.Touch Only: Contact-type Touch PenTouch & Remote: Contact-type Touch Pen and remote pointerSLOT INPUT – NETWORKSet “On” or “Off” for each input terminal.If you switch to the input terminal that is set to “On”, the mode becomes Touch Penmode.“Touch-Pen: On” is displayed in Touch Pen mode.Notes:• When the following signal input, “Touch-Pen Settings” are disabled:50i/50p/25p/24sF/24p signals and PC format signals with 50 Hz vertical frequency.• The electronic pen cannot be used when VIDEO or COMPONENT input is selected.• The electronic pen cannot be used during Digital Zoom. (see page 21)• When using the electronic pen, adjust “Pos./Size” so that the screen of the computer can be correctly displayed.(see page 23)Setting the Remote ControlYou can also turn Touch Pen mode On/Off with the FUNCTION buttons on the remote control. (see page 42)In Touch Pen mode, the menus and functions are restricted as follows.Pos./Size menu 1:1 Pixel Mode: OnOver scan: OffPicture menu Picture Mode: Fixed to “Normal” (see page 26)Setup menuSignalExtended life settingsMULTI DISPLAY SetupPortrait SetupFRAME CREATION: OffPicture Mode: Fixed to “Normal” (see page 37)MULTI DISPLAY Setup: OffPortrait Setup: OffOptions menu Display size: UnavailableRotate: UnavailableASPECT Controls 16:9OnTouch-Pen