64Speci cationsTH-85PB1E TH-103PB1EPower Source 220 - 240 V AC, 50/60 HzPower ConsumptionPower on 1,090 W 1,250 WStand-by condition 0.5 W 0.5 WPower off condition 0.3 W 0.3 WPlasma Display panel Drive method : AC type 85-inch,16:9 aspect ratioDrive method : AC type 103-inch,16:9 aspect ratioScreen size 1,889 mm (W) × 1,062 mm (H)× 2,167 mm (diagonal)2,269 mm (W) × 1,276 mm (H)× 2,603 mm (diagonal)(No.of pixels) 2,073,600 (1,920 (W) ×1,080 (H))[5,760 × 1,080 dots]Operating conditionTemperature 0 °C - 40 °CHumidity 20 % - 80 %Applicable signalsColour System NTSC, PAL, PAL60, SECAM, Modied NTSCScanning format 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 750 (720) / 60p · 50p, 1125 (1080) / 60i · 60p · 50i ·50p · 24p · 25p · 30p · 24sF, 1250 (1080) / 50iPC signals VGA, SVGA, XGA, SXGAUXGA ···· (compressed)Horizontal scanning frequency 15 - 110 kHzVertical scanning frequency 48 - 120 HzConnection terminalsAV IN VIDEOAUDIO L-RBNCRCA Pin jack × 21.0 Vp-p (75 )0.5 Vrms, Shared with COMPONENT/RGB INHDMI TYPE A ConnectorCOMPONENT/RGB INY/GP B/CB/BPR /CR /RAUDIO L-RBNCBNCBNCRCA Pin jack × 2with sync 1.0 Vp-p (75 )0.7 Vp-p (75 )0.7 Vp-p (75 )0.5 Vrms, Shared with VIDEODVI-D INAUDIODVI-D 24 PinContent ProtectionStereo mini jack (M3) × 1Compliance with DVI Revision 1.0Compatible with HDCP 1.10.5 Vrms, Shared with PC INPC INAUDIOHigh-Density Mini D-sub 15 PinStereo mini jack (M3) × 1Y or G with sync 1.0 Vp-p (75 )Y or G without sync 0.7 Vp-p (75 )PB/CB/B: 0.7 Vp-p (75 )PR /CR /R: 0.7 Vp-p (75 )HD/VD: 1.0 - 5.0 Vp-p (high impedance)0.5 Vrms, Shared with DVI-D INSERIAL External Control TerminalD-sub 9 Pin RS-232C compatibleWIRELESS MODULE for Wireless module (ET-WM200E)LAN RJ45 10BASE-T/100BASE-TX, compatible with PJLink™AUDIOOUTL-R RCA Pin jack × 2 (L / R)OUTPUT LEVEL : VARIABLE (- ~ 0 dB) [INPUT 1 kHz / 0 dB, 10 k Load]SoundSpeakers 160 mm × 40 mm × 2 pcsAudio Output 20 W [10 W + 10 W] (10 % THD)Dimensions (W × H × D) 2,015 mm × 1,195 mm × 99 mm 2,412 mm × 1,419 mm × 134 mmMass (weight) approx. 115 kg net approx. 189 kg netNotes:• Design and specications are subject to change without notice. Mass and dimensions shown are approximate.• This equipment complies with the EMC standards listed below.EN55022, EN55024, EN61000-3-2, EN61000-3-3.