Panasonic TH-103PB1U Operating Instructions Manual

Also see for TH-103PB1E: Operating instructions Service manual

Contents

Panasonic TH-103PB1U Operating Instructions Manual Manual pdf 49 page image

49Setup for Input SignalsSignal menuNotes:• “Signal” setup menu displays a different setting condition for each input signal.• Depending on the input signal type, an optional Terminal Board may be required.• 3D Y/C Filter (NTSC)This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.Set this menu when the moving image looks unnatural during Video (S Video) input signal.On OffNote:When On, this setting only affects NTSC input signals.• Colour systemAuto SECAM M.NTSC NTSCPALSet the colour system to match the input signal. When “Auto” is set, Colour system will be automatically selectedfrom NTSC/PAL/SECAM/M.NTSC.To display PAL60 signal, select “Auto” or “PAL”.If the picture image becomes unstable:With the system set on Auto, under conditions of low level or noisy input signals the image may in rare casesbecome unstable. Should this occur, set the system to match the format of the input signal.• Cinema realityWhen “On”, the display attempts to reproduce a more natural interpretation of sources such as movie pictures,which are recorded at 24 frames per second.If the picture is not stable, turn the setting to “Off”.On OffNote:When On, this setting only affects the following signal input:• NTSC / PAL signal input during Video (S Video) input signal.• 525i(480i), 625i(575i), 1125(1080)/60i signal input during “Component” input signal.• XGA ModeThis menu is displayed when the input signal is analog (Component/PC). This unit supports three types of XGAsignals with 60Hz vertical frequency having different aspect ratios and sampling rates (1,024 × 768 @ 60Hz,1,280 × 768 @ 60Hz and 1,366 × 768 @ 60Hz).Auto 1024×768 1280×768 1366×768Auto: Automatically selected from 1024×768/1280×768/1366×768.Switch the setting to suit the input signal for better display depends on the angle of view or displayresolution condition.Note:After making this setting, be sure to make each adjustment (such as “Auto Setup”) on the “Pos./Size” menu asnecessary. (see page 23)Select “Signal” in “Setup” menu and press button.Cinema realitySignalOffH-Freq. kHz63.98V-Freq. Hz60.02Noise reduction Off[ Digital ]Signal Format 1280×1024/60iFRAME CREATION MidHDMI Range AutoSyncSignalH-Freq.V-Freq.kHzHz63.9860.02Signal Format 1280×1024/60iCinema realityNoise reductionXGA ModeAutoOffOffAuto[ Component ]FRAME CREATION MidSyncSignalH-Freq.V-Freq.kHzHz63.9860.02Signal Format 1280×1024/60i[ RGB ]Cinema realityNoise reductionXGA ModeAutoOffOffAutoFRAME CREATION MidFor Video (S VIDEO) For RGBFor Component For DigitalFRAME CREATIONColour systemSignalMidAutoCinema reality Off[ AV ]Noise reduction Off