44 45FAQs, etc.SpecificationsFrequently Asked QuestionsFAQ25.9 ” (657 mm) 4.6 ” (117 mm)11.8 ” (300 mm)18.6 ” (473 mm)20.7 ” (525 mm)31.1 ” (791 mm)19.8 ” (504 mm) 19.8 ” (504 mm)4.6 ” (117 mm)11.8 ” (300 mm)22.2 ” (563 mm)24.2 ” (615 mm)TC-26LX600 TC-32LX600Power Source AC 120 V, 60 HzPower ConsumptionAverage useMaximum CurrentStandby condition113 W2.2 A0.6 W126 W2.4 A0.6 WAspect Ratio 16:9Visible screen size(W × H × Diagonal)(No. of pixels)26.0 ” DIAGONAL (66.1 cm DIAGONAL) 31.5 ” DIAGONAL (80.0 cm DIAGONAL)22.7 ” × 12.8 ” × 26.0 ”(576 mm × 324 mm × 661 mm)27.5 ” × 15.4 ” × 31.5 ”(698 mm × 392 mm × 800 mm)1,049,088 (1,366 (W) × 768(H)) [4,098 × 768 dots]SoundSpeaker 2.36 ” × 4.7 ” (60 mm × 120 mm) Full-range × 2 pcsAudio Output 20 W [ 10 W + 10 W ] ( 10 % THD )Headphones M3 (3.5mm) Jack × 1Channel Capability-ATSC/NTSC (Digital/Analog) VHF/ UHF : 2-69, CATV:1-135Operating Conditions Temperature : 32 °F -95 °F (0 °C – 35°C)Connection TerminalsINPUT 1-2VIDEO : RCA PIN Type × 1 1.0 V[p-p] (75 ȍ)S VIDEO : Mini DIN 4-pin Y:1.0 V[p-p] (75 ȍ) C:0.286 V [p-p] (75 ȍ)AUDIO L - R : RCA PIN Type × 2 0.5 V [rms]INPUT 3 VIDEO : RCA PIN Type × 1 1.0 V [p-p] (75 ȍ)AUDIO L - R : RCA PIN Type × 2 0.5 V [rms]COMPONENTVIDEO INPUTY : 1.0 V [p-p] (including synchronization)PB, PR : ±0.35 V [p-p]AUDIO L-R : RCA PIN Type × 2 0.5 V [rms]HDMI 1-2AUDIO INTYPE A Connector × 2AUDIO L - R : RCA PIN Type × 2 0.5 V [rms]OUTPUT VIDEO : RCA PIN Type × 1 1.0 V [p-p] (75 ȍ)AUDIO L - R : RCA PIN Type × 2 0.5 V [rms]DIGITAL AUDIO OUT PCM / Dolby Digital, Fiber OpticFEATURES3D Y/C Digital Comb Filter, CLOSED CAPTION, V-ChipHDMIVesa compatibleDimensions(W × H × D)Including TV stand 25.9 ” × 20.7 ” × 11.8 ”(657 mm × 525 mm × 300 mm)31.1 ” × 24.2 ” × 11.8 ”(791 mm × 615 mm × 300 mm)TV Set only 25.9 ” × 18.6 ” × 4.6 ”(657 mm × 473 mm × 117 mm)31.1 ” × 22.2 ” × 4.6 ”(791 mm × 563 mm × 117 mm)Weight 36.4 lb. (16.5 ) NET 43.0 lb. (19.5 ) NETSpecificationsNote• Design and Specifications are subject to change without notice. Weight and Dimensions shown are approximate.[TC-26LX600] [TC-32LX600]If there is a problem with your TV please refer to the table below to determine the symptoms, then carry out thesuggested check. If this does not solve the problem, please contact your local Panasonic dealer, quoting the modelnumber and serial number (both found on the rear of the TV).Symptoms ChecksPicture SoundNoisy SoundSnowy PictureNormal SoundMultiple ImagesNoisy SoundInterferenceNo SoundNormal PictureNo SoundNo PictureNormal SoundNo colorWeak or No SoundPoor or Distorted PictureWeak, Wrong or No SoundNormal PictureCannot operate with the remote control.There may be red spots, blue spots,green spots and black spots on thescreen.The main unit is hot.• Antenna location, direction or connection.• Antenna location, direction or connection.• Electrical appliances.Cars / Motorcycles.Fluorescent lights.• Volume level.Sound mute switched on.STEREO/SAP/MONO• TV set to AV mode.Not plugged into wall outlet.Not switched on.Picture / Sound controls set at minimum levels.• Color controls set at minimum levels.Weak signal.• Retune Channel (s).• Sound reception may have deteriorated.Set STEREO/SAP/MONO setting to SAP or MONO until reception improved.• The battery/ies is/are exhausted.The batteries’ polarity is wrong.The remote control sensor is exposed to strong light from a fluorescentlamp, etc.• This is a characteristic of liquid crystal panels and is not a problem. Theliquid crystal panel is built with very high precision technology giving youfine picture details. Occasionally, a few non-active pixels may appear on thescreen as fixed points of red, blue, green, or black.Please note this does not affect the performance of your LCD.• The main unit radiates heat and some of the parts may become hot. This isnot a problem for performance or quality.Set up in a location with good ventilation.Do not cover the ventilation holes of the TV with a tablecloth, etc., and donot place on top of other equipment.“Control with HDMI”function does not work • Switch the TV unit on again with the equipment on.• Set “Control with HDMI” to “Off”, then set to “On” again. (p. 21)