INSTALLATIONInstallation Manual 392.1.2 Wiring• To assure good quality telephone connection, it is recommended new and modifications toexisting installation of customer premise wiring shall use solid twisted pair copperconductors with minimum 24 gauge that comply with the electrical specifications forCategory 3 wiring as detailed in ANSI/EIA/TIA-570A Building Wiring Standards.• Do not wire the telephone cable parallel to an AC power source, computer, etc. If cablesare run near those wires, shield them with metal tubing or use shielded cables and groundthe shields.• Use protectors if running cables on the floor. Avoid running cables under carpets.• Avoid sharing a 120 V AC power supply for computers, telexes, and other office equipmentwith the VPS. Induction noise from such equipment may interrupt the VPS operation.When making any connections or removing the cover, be sure the power switch is turned off.When installing telephone wiring, basic safety precautions should always be followed toreduce the risk of fire, electric shock and injury to persons, including the following:• Never install telephone wiring during a lightning storm.• Never install telephone jacks in wet locations unless the jack is specifically designed forwet locations.• Never touch uninsulated telephone wires or terminals unless the telephone line has beendisconnected at the network interface.• Use caution when installing or modifying telephone lines.NoteIf you live in an area that can have frequent power failures, we strongly recommend that youpurchase a suitable UPS (uninterruptible power supply) for your VPS (and PBX if needed).The power rating of your VPS may be found in the specifications.
