SYSTEM MAINTENANCE AND TROUBLESHOOTING182 Installation Manual7.2.8 Loading New or Saved Data to the VPS (LOAD)Use the LOAD command to install new data or to restore saved data to the VPS. Execute thiscommand for each data file.When performing this operation, always wait until the process completion indication appearsbefore proceeding.1. Type LOAD, then Press RETURN.2. Select the item to be restored to the hard disk, then Press RETURN.3. Press RETURN.When "CCC" appears, the VPS is ready for loading.4. Set the data terminal to the sending (Call) mode (Xmodem). Then enter the backupfilename. Press ENTER. The backup data will be restored to the hard disk.5. When the load to the VPS has been completed, power-off and restart the VPS.Notes• The data terminal that you use must be equipped with communications software thatsupports the Xmodem file transfer protocol. The command can be canceled by Typing[\] before entering the sending mode. Once the sending mode has been selected, usethe cancel command of the communication software being used.• If your data terminal supports a high speed, it is recommended that you LOAD at themaximum speed of 38400 bps. First, change the RS-232C setting of the VPS (seeB7.1 RS-232C Parameters). Next, change the RS-232C setting of your data terminalto the same speed.$ LOADVPS Disk Data Load (PC -> VPS : Xmodem)1: Program2: Parameters3: System Prompts4. User Prompts-15. User Prompts-26. Custom Service Menus7. Personal Greetings8. Company GreetingsSelection No.:=To start press 'RETURN'- - - - - - Load Start!!
