Station Features and Operation (PT/SLT)160 User ManualEntering account codes during or after a conversationDuring a conversation or within 15 seconds after the other party hangs up;ConditionsYour Account Code Entry mode is set to one of the following three modes by SystemProgramming.In "Verified - All Calls" mode• You must always enter a system-registered account code to make a CO call.• If the account code you entered is not found in the System Account Code Table, you hear a reorder tone.• You can enter any account code during and after a call (after a CPC signal*1 isdetected).In "Verified - Toll Restriction Override" mode• You can override the Toll Restriction imposed on your extension by entering asystem-registered account code before making a CO call (Toll Restriction Overrideby Account Code Entry).• If the account code you entered is not found in the System Account Code Table, you hear a reorder tone.In "Option" mode• You can enter any account code when needed. It is possible to record a calling orcalled party's account code in the SMDR, during a conversation or within 15 secondsafter the other party hangs up.• You can enter any account code during and after a call (after a CPC signal*1 isdetected).General• To clear and re-enter the account code, press " ."*1 A Calling Party Control (CPC) signal is an on-hook indication sent from a CO line when the other end hangs up. You hear areorder tone when the signal is detected.PT7230 / 7235 / 7433 / 7436account codeEnter an account(10 digits max., 0...9).Press Account(flexible button).The correspondingindicator light turns on.You can keep talking.Press ACCNT (S3).ACCNTS1 S2 S3 account codeEnter account code(10 digits max., 0...9).You can keep talkingDial #. Dial #.(Account)
