Features 3-33 Features AAccount Code EntryAn account code is used to identify incoming and outgoing outside calls for accounting andbilling purposes. The account code is appended to the SMDR call record. For incomingoutside calls, an account code is optional. For outgoing outside calls, there are 4 accountinput modes programmable in program [605], Option, Forced, Verify–All and Verify–Toll.Option: A 4-digit code may be entered during a conversation or within 30 secondsafter a conversation when a record is needed.Forced: A 4-digit code must be entered within 5 seconds after an exchange line isseized. The code can be any number.Verify–All: Enables to make an outside call if the code entered within 5 seconds after anextension user seizes an exchange line is the same as one of the accountcodes programmed in [310].Verify–Toll: Enables to override call barring temporarily by entering one of the accountcodes programmed in [310] within 5 seconds after an exchange line isseized. Calls with COS numbers 3 through 5 will be treated as calls withCOS number 2. Calls with COS numbers 1 and 2 will not be affected.• Required System Programming[310] Account Codes[601]-[603] Call Barring – Class of Service Assignment —Day/Night/Lunch[605] Account Code Entry Mode[805] SMDR Account Code Selection• Related Feature ReferencesStation Message Detail Recording (SMDR),Call Barring Override by Account Codes• Operating Instructions Reference1.7 Useful Features, “Calling with Account Codes (Account Code Entry)”+Alternate Calling – Ring/VoiceThis system offers a proprietary telephone user 2 types of intercom calling, Voice Call modeand Tone (ring) Call mode. “Voice Call” informs the called party of an incoming call withthe calling party’s voice, while “Tone Call” uses a ring tone. A proprietary telephone usercan select “Voice Call” or “Tone Call” in the Proprietary Telephone Settings. If the userselects “Voice Call”, the calling party can talk to the user immediately after the confirmationtone. The calling party can switch the pre-set mode at the called extension, from “VoiceCall” to “Tone Call” or vice versa, by pressing “ ” after dialling the extension number.• A rotary telephone user cannot change the pre-set mode at the called extension.• Operating Instructions References1.2 Proprietary Telephone Settings, “Customising Your Telephone Functions”, IntercomAlert Assignment1.7 Useful Features, “Alternate Calling – Ring/Voice”+!!
