4-68 System Programming[524]-[526] 4.2 System ProgrammingAssigns the length of time for the Intercept Routing – No Answer feature (+ [524] “UCDIntercept Mode”, Intercept). When the time expires, the system starts to redirect the call tothe programmed extension(s).Default 20 seconds• Feature ReferencesSection 3, FeaturesIntercept Routing, Uniform Call Distribution (UCD)[525] UCD Ringing Time before Intercept*125 NEXT5 STORE ENDSELECT(10/20/30/40/60/120 sec)Assigns the length of time to call the extension(s) where a call is redirected by the InterceptRouting – No Answer feature (+ [524] “UCD Intercept Mode”, Intercept) after the timeprogrammed in [525] “UCD Ringing Time before Intercept” expires.Default 20 seconds• Feature ReferencesSection 3, FeaturesIntercept Routing, Uniform Call Distribution (UCD)[526] UCD Ringing Time after Intercept* 125 NEXT6 STORE ENDSELECT(10/20/30/40/60/120 sec)++Selects the operation when all extensions in the UCD group do not answer an outside callvia the UCD feature within the length of time programmed in [525] “UCD Ringing Timebefore Intercept”. Intercept or Disconnect is available.Intercept: The call is redirected depending on programs [408]-[410] “Flexible RingingAssignment–Day/Night/Lunch” (Intercept Routing – No Answer feature).Disconnect: The call is disconnected.Default Intercept• Feature ReferencesSection 3, FeaturesIntercept Routing, Uniform Call Distribution (UCD)[524] UCD Intercept Mode*125 NEXT4 STORE ENDSELECT(Intercept/Disconnect)+*1: Required only when the optional OGM/FAX DetectionCard is installed.
