System Programming 4-674.2 System Programming [522]-[523]Assigns interval time between sending UCD outgoing messages to an incoming outside callvia the UCD feature when all extensions in the UCD group are busy. The UCD outgoingmessage is repeated during the time programmed in [521] “UCD Busy Waiting Time”.Default 1 minute• Feature ReferenceSection 3, FeaturesUniform Call Distribution (UCD)[522] UCD OGM Message Interval Time*125 NEXT2 STORE ENDSELECT(30 sec/1/1.5/2 min)+*1: Required only when the optional OGM/FAX DetectionCard is installed.Selects the operation when the length of time programmed in [521] “UCD Busy WaitingTime” expires. Intercept or Disconnect is available.Intercept: The call will be redirected depending on programs [408]-[410] “FlexibleRinging Assignment–Day/Night/Lunch” (Intercept Routing feature). Theextension which receives a redirected call rings during the length of timeprogrammed in [526] “UCD Ringing Time after Intercept”.Disconnect: The call will be disconnected immediately.Default Intercept• The above-mentioned intercept only occurs when “MODE 3” or “MODE 5” is selected inprogram [502] “OGM Mode Selection”. If “MODE 4” is selected, the call will bedisconnected after the UCD-END outgoing message. If “MODE 6” is selected and“Intercept” is assigned in this program, the call will go to the DISA and OGM2 will beheard by the caller.• Feature ReferencesSection 3, FeaturesIntercept Routing, Uniform Call Distribution (UCD)[523] UCD Busy Mode*125 NEXT3 STORE ENDSELECT(Intercept/Disconnect)!!+
