System Programming 4-834.2 System Programming [801]-[802]Assigns the following 2 printing parameters to match the SMDR output with the paper sizeused in the printer.Page Length: Sets the number of lines per page.Skip Perf: Sets the number of lines to be skipped at the end of every page.Default Page length – 66 linesSkip perforation – 0 line• The page length should be at least 4 lineslonger than the skip perforation length.• To correct a wrong entry, press the CLEARbutton and enter the new one.• Feature ReferenceSection 3, FeaturesStation Message Detail Recording (SMDR)108[801] SMDR ParameterNEXT STORENEXT< Sets the page length >< Sets the skip perforation >!! 66 lines pagelengthskipperforationmachineperforationStandard paperfor the SMDR(11 inches)page length(4 ··· 99)skip perforation(0 ···95)ENDSTOREDetermines which calls will produce an SMDR printout.*1 Outgoing: On (Print all calls) / Off (No printing) / Toll (Print toll calls only)*2 Incoming: On (Print all calls) / Off (No printing)Default Outgoing calls / Incoming calls – On• If “Outgoing; Toll” is selected, only calls which are checked in programs [302]–[305] “CallBarring – Classes 2 through 5 Denied Codes” and are allowed, are printed out.• Feature ReferenceSection 3, FeaturesStation Message Detail Recording (SMDR)[802] Incoming/Outgoing Call Selection for Printing208 NEXT SELECT(On/Off/Toll)*1STORE NEXT SELECT(On/Off)*2STORE< Sets an outgoing call > < Sets an incoming call >!!END++(Perforation)
