Notice• Only one account can be logged in to the Web user interface at a time. If you try to access the Webuser interface while someone is logged in, you will be denied access.• You cannot log in to the Web user interface even under the same account as someone who is alreadylogged in.• The user password is required to change the settings.• The IDs can be changed through configuration file programming (® see "ADMIN_ID" and"USER_ID" in 5.3.8 HTTPD/WEB Settings).• If you forget your account IDs or passwords, consult your phone system dealer/service provider.1.1.6.4 Accessing the Web User InterfaceThe unit can be configured from the Web user interface.To access the Web user interface1. Open your Web browser, and then enter "http://" followed by the unit’s IP address into the address field ofyour browser.a. When the IP address is 192.168.0.1 (IPv4), access the following URL.http://192.168.0.1/b. When the IP address is 2001:db8:1f70::999:de8:7648:6e8 (IPv6), access the following URL. With IPv6,the IP address is enclosed in square brackets ("[" and "]").http://[2001:db8:1f70::999:de8:7648:6e8]/Note• To determine the unit’s IP address, perform the following operations on the unit:1.2. [ ]/[ ]: "System Settings" ®OK3. [ ]/[ ]: "Status" ®OK4. [ ]/[ ]: "IPv4 Settings"/"IPv6 Settings" ®OK5. [ ]/[ ]: "IP Address".2. For authentication, enter your ID (username) and password, and then click OK.Notice• The default ID for the User account is "user", and the default password is blank. The ID cannot bechanged from the Web user interface, but it can be changed through configuration fileprogramming.• When you log in as User to the Web user interface for the first time, the [User PasswordSettings] screen (® see 4.4.2 User Password Settings) will be displayed. Enter a new password,and then perform authentication again with the new password to log in to the Web user interface.• The default ID for the Administrator account is "admin", and the default password is "adminpass".The ID cannot be changed from the Web user interface, but it can be changed through configurationfile programming.3. The Web user interface window is displayed. Configure the settings for the unit as desired.4. You can log out from the Web user interface at any time by clicking [Web Port Close].Document Version 2015-02 Administrator Guide 271.1.6 Web User Interface Programming
