Configuring the Network Settings of the UnitThe following procedures explain how to change the network settings via the unit.For details about the individual network settings that can be configured via the unit, refer to the OperatingInstructions on the Panasonic Web site (® see Introduction).For details about configuring network settings via the Web user interface, see 4.3.1 Basic NetworkSettings.To configure IP Mode (IPv4, IPv6, IPv4&IPv6)1.2. [ ]/[ ]: "System Settings" ®OK3. [ ]/[ ]: "Network Settings" ®OK4. [ ]/[ ]: "IP Mode Select" ®OK5. [ ]/[ ]: "IPv4" / "IPv6" / "IPv4&IPv6" ®OK• The initial value is "IPv4".Configuring the Network Settings Using IPv4To configure network settings automatically1.2. [ ]/[ ]: "System Settings" ®OK3. [ ]/[ ]: "Network Settings" ®OK4. [ ]/[ ]: "IPv4 Settings" ®OK5. [ ]/[ ]: "DHCP" ®OK6. [ ]/[ ]: "Auto" ®OK• Select "Manual" to enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2(secondary DNS server) manually, and then pressOK .To configure network settings manually1.2. [ ]/[ ]: "System Settings" ®OK3. [ ]/[ ]: "Network Settings" ®OK4. [ ]/[ ]: "IPv4 Settings" ®OK5. [ ]/[ ]: "Static" ®OK6. Enter the IP address, subnet mask, default gateway, DNS1 (primary DNS server), and, if necessary, DNS2(secondary DNS server), and then pressOK .Configuring the Network Settings Using IPv6To configure network settings automatically using DHCP1.2. [ ]/[ ]: "System Settings" ®OK3. [ ]/[ ]: "Network Settings" ®OK4. [ ]/[ ]: "IPv6 Settings" ®OK5. [ ]/[ ]: "DHCP" ®OK22 Administrator Guide Document Version 2015-021.1.3 Basic Network Setup
