Panasonic KX-HDV100 Administrator's Manual

Also see for KX-HDV100: Operating instructions Supplement for administrator guide Supplement for administrator guide

Contents

Panasonic KX-HDV100 Administrator's Manual Manual pdf 131 page image

Value Range 0, 200–2000 (0: No tone)Note• If the value for this setting is "350,440", the unit will use a mixedsignal of a 350 Hz tone and a 440 Hz tone.Default Value 350,440Configuration File Reference DIAL_TONE1_FRQ (Page 246)Tone TimingsDescription Specifies the pattern, in milliseconds, of dial tones using up to 10 wholenumbers (off 1, on 1, off 2, on 2…) separated by commas.Note• The unit will not play the tone for the duration of the first value,play it for the duration of the second value, stop it for theduration of the third value, play it again for the duration of thefourth value, and so on. The whole sequence will then repeat.For example, if the value for this setting is "100,100,100,0", theunit will not play the tone for 100 ms, play it for 100 ms, stop itfor 100 ms, and then play it continuously.• It is recommended that you set a value of 60 milliseconds ormore for the first value (off 1).Value Range 0–16000 (0: Infinite time)Note• Avoid setting 1–50 for any of the values.Default Value 60,0Configuration File Reference DIAL_TONE1_TIMING (Page 246)4.6.5.2 Busy ToneTone FrequenciesDescription Specifies the dual-tone frequencies, in hertz, of busy tones using 2whole numbers separated by a comma.Value Range 0, 200–2000 (0: No tone)Note• If the value for this setting is "480,620", the unit will use a mixedsignal of a 480 Hz tone and a 620 Hz tone.Default Value 480,620Configuration File Reference BUSY_TONE_FRQ (Page 249)Document Version 2015-02 Administrator Guide 1314.6.5 Tone Settings