Panasonic Electric Works Fire & Security Technology Europe ABMEW00748 Rev: 1 Operating Instructions Fire alarm system EBL512 V2.3.x64Now, an automatic reset/restart will take place (see chapter "Restart",page 69.If the download was not okey the following text message will beshown:Checksum fault in downloaded data.Control unit will now restartNow, an automatic reset/restart will take place (see chapter "Restart",page 69.After the reset/restart another text message will be shown in thedisplay:FAULT: Site specific data (SSD), CU nnDate: MM-DD Time: HH:MMThis text message means that the SSD have not been downloaded, i.e.a new download has to be performed.18.3 Control Units in a TLON networkThe SSD for all control units can be downloaded via one control unit.Start the download from Win512. The download will now beperformed to the control units, one at a time, according to the chapter"Single Control Unit" above. 60When the download to a control unit is completed, an automaticreset/restart will take place in that control unit (see chapter "Restart",page 69.18.4 User definable text messages downloadWhen a fire alarm is activated (e.g. an addressable alarm point), thepresentation number (Zone & Address) will be shown on the first rowin the control units' and the ext. FBP:s' alphanumeric display.61 Onthe second row will be shown a user definable text message ifprogrammed.Each alarm point can have a unique text message. When severalalarms are activated (in one or more zones) and only the zone numbersare shown, each zone can have a unique text message.Each zone line input can have a unique text message.The user definable text messages will be printed out when a printer isavailable.60 Downloading is performed in a consecutive order, i.e. 0-1-2-3-4-……-29(amongst the selected control units) but the control unit where the PC isconnected will automatically be the last one to get the SSD downloaded.61 Also valid for the Ext. Presentation unit 1728 and the Alert Annunciationunits 1735 / 1736.