Panasonic AY-RP500 Installation Manual

Also see for AY-RP500: Installation manual Service manual

Contents

Panasonic AY-RP500 Installation Manual Manual pdf 54 page image

523.3. SCSI Device Setup CheckPress [Ctrl]+[A] on the BIOS screen to show the SCSIUtility screen and check the following.(a) Are all the maximum sync transfer rate settings 40.0MB? (Check both channels A and B.)(b) Are all the connected disks Verify once on the SCSIUtility? (Check both channels A and B.)3.4. Setup Check with AdministratorStart the administrator panel by taking the steps in theorder of "Start" p"Program" p "Management Tools(Common)" p "Disk Administrator", and check thefollowing.(a) Are all the connected disks displayed?(b) Is the drive name of disk 0 "C:"?(c) Is the format of disk 0 "NTFS"?(d) Is a drive name allocated to the disk for audio datastorage? (If there are two or more disks for audiodata storage, check it for all the disks.)(e) Is the format of the disks for audio data storage"NTFS"? (Check it for all the disks for video and titledata storage.)( f ) Is a drive name allocated to the disk for video andtitle data storage? (If there are two or more disks forvideo and title data storage, check it for all the disks.)(g) Is the format of the disks for video and title datastorage "Unknown"? (Check it for all the disks forvideo and title data storage.)3.5. Virtual Memory Setup CheckOpen the Control Panel by taking the steps in the orderof "Start"p"Setup"p"Control Panel".Then, double-click the icon "System" to open the systemproperty menu, and select the tab "Performance". Clickthe button, one of the virtual memory items, toopen the virtual memory panel, then check the following.(a) Is the drive set in the paging file "C:"?(b) Is the initial size of the paging file 300 MB?(c) Is the maximum size of the paging file 400 MB?Change1. Board Installation Check(a) Is the Targa board installed in the first slot from theCPU?(b) Is the SCSI board installed in the second slot from theCPU?(c) Is the JOG board inserted?(d) If the Targa board clamp has a grounding wireattached to it, is the grounding wire connected to thecabinet?2. Cable Connection Check(a) Is the keyboard connected?(b) Is the mouse connected?(c) Aren't the keyboard and mouse connected the otherway round?(d) Is the power cable connected?(e) Is the forked cable connected to the Targa board andVGA card correctly and fastened with screws,respectively?( f ) Is the VGA cable connected and screwed to theforked cable?(g) Is the VTR control cable connected?(h) Is the VTR switched on?( i ) Is the VTR switch in the Remote position?( j ) Is JOGPAD connected?(k) Is the LTC cable connected?( l ) Are the video input/output cables connected andscrewed to the Targa board?3. Check After Switching Power On3.1. Starting Screen Check(a) Is the memory capacity (standard: 64 MB) normal?(b) Is the CD-ROM drive name displayed (onlymomentarily)?(c) Is the system disk name displayed?(d) Is the SCSI card name displayed?(e) Are all the SCSI disk names displayed?3.2. BIOS Setup Check(a) Is Power Management disabled?(b) Is Plug&Play OS set to No?DVEdit INSTALLATION CHECK ITEMS